knowledge base

How does a constructed wetland work?

Kadlec & Wallace, Treatment Wetlands, 2nd ed.

IWA Specialist Group on Wetland Systems for Water Pollution Control

A constructed wetland  mimics the purifying effect of a natural marsh, but in a technically controlled way and optimally designed for wastewater treatment. No chemicals, low energy consumption, little maintenance, and a valuable ecosystem as a by-product.

The four players in treatment

Component

Role

Reeds and other marsh plants

Transport oxygen to the root zone, plant uptake of nutrients (nitrogen, phosphorus), create a large surface area for bacteria on stems and roots

Substrate (sand, gravel, lava, expanded clay pellets, shells)

Filters suspended particles, provides attachment sites for biofilm, binds phosphate (depending on the type of substrate)

Biofilm (bacteria on substrate and roots)

Breaks down organic matter; converts ammonium into nitrate (nitrification) and nitrate into nitrogen gas (denitrification)

Water movement

Distributes pollution evenly, ensures contact with biofilm, prevents dead zones

Step by step: what happens to the wastewater?

Step 1 – Primary settling

The wastewater first flows through a primary settling tank (septic tank, Imhoff tank or settling pit). Coarse particles and settleable sludge are removed. This prevents the wetland from clogging.

Step 2 – Distribution over the reed bed

The pre-settled water is evenly distributed over the filter bed:

In a vertical-flow system: via a pipe network on top of the filter

In a horizontal-flow system: via an inlet on one side

Step 3 – Treatment in the filter bed

Suspended particles → are mechanically trapped in the pores of sand and gravel.

Organic matter (fats, proteins, sugars) → bacteria in the biofilm break it down under aerobic (oxygen-rich) conditions.

Ammonium (NH₄⁺) → is converted by bacteria into nitrate (nitrification). In a vertical-flow filter this happens at the top; in a horizontal-flow filter it is limited due to lack of oxygen.

Nitrate (NO₃⁻) → is converted in oxygen-poor zones into harmless nitrogen gas (denitrification), which escapes into the air.

Phosphate (PO₄³⁻) → binds to iron, aluminum or calcium in the substrate. The plants also take up part of it; by periodically harvesting reeds, phosphorus is structurally removed.

Pathogens (bacteria such as E. coli) → are inactivated by UV light at the surface, predation by microorganisms and natural degradation.

Step 4 – Collection and discharge of treated water

At the bottom of the filter (or on the opposite side in horizontal systems), the treated water is collected. It can then:

be discharged directly into surface water

infiltrate into the soil

be reused (e.g. for irrigation or flushing water)

Vertical versus horizontal flow

Characteristic

Vertical flow

Horizontal flow

Water movement

From top to bottom (in batches)

From side to side (continuous)

Oxygen availability

High (draining draws in air)

Low (filter remains saturated)

Nitrification (ammonium removal)

Very good

Limited

Denitrification (nitrate removal)

Moderate (requires a post-treatment zone)

Good (oxygen-poor environment)

Surface area requirement

Relatively small

Larger

Typical application

Domestic and industrial wastewater with ammonium

As a final stage after a vertical filter, or for nitrate-rich flows

Does a reed bed also work in winter?

Yes, provided it is well designed. In areas with moderate cold temperatures and only 15 days of frost, only the insulation of the reed on the wetland is sufficient. The next measures can be taken into account in colder regions for frost resistance:

Insulating top layer (e.g. straw, wood chips or a thick layer of reed litter)

Install distribution pipes frost-free (deeper than 60 cm or covered)

During extremely cold periods: temporarily raise the water level (a layer of ice on top insulates)

Treatment efficiencies decrease by 10–20% in winter, but recover automatically in spring.

What does not happen (common misconceptions)

Reeds do not directly treat; it is mainly the biofilm (micro-organisms) on the roots. The plants transport oxygen and provide attachment surface for biofilm.

A properly functioning treatment wetland does not smell. Odor indicates overloading, dead zones, or design errors.

It is not a swimming pond – unless specifically designed for bathing water quality with UV post-treatment.

The reeds do not need to be harvested for the system to work (but annual harvesting does promote the spring growth of the new reed shoots.

Treatment efficiencies (guideline values)

Parameter

Removal percentage

BOD (biochemical oxygen demand)

85–99%

COD (chemical oxygen demand)

70–95%

Suspended solids

80–95%

Total nitrogen

50–80%

Total phosphorus

40–90% (depending on substrate)

E. coli

99–99.9% (2–3 log)

blogs

In the spotlight

In our blogs, we share insights, developments, and practical knowledge about water treatment and circular water use.

contact

How can we help you?

Do you have questions about any of our products or services? Feel free to contact us!